USB data communication between the portable eddy current flaw detector, ultrasonic flaw detector can be connected to a computer MUT600B is a fully digital portable ultrasonic flaw detector that can quickly and easily, without damage to accurately perform a variety of defects (cracks, inclusions, porosity, etc.) within the workpiece The detection, location, assessment and diagnosis. Both for the laboratory, but also for engineering field testing. Mattel detector data communication of the instrument with a USB communication interface enables communication with a PC. The top end of the USB cable into the computer's USB communication socket, the other end of the plug into the USB port on the computer chassis. The instrument is turned on, run DataPro detector data management software on a PC, according to DataPro data management software operation manual guidelines, can be stored in the instrument graphics and data upload to the PC, testing results will generate test reports, and can be saved , print and other operations. Note: u connect or disconnect the communication cable plug socket before communication with the instrument, first turn off the power to the instrument. u communication during non-destructive weld flaw detector, do not pull out your communication cable, and turn off the PC software, otherwise it will lead to a communication failure so that the instrument can not continue to work. u If an exception occurs leading to communication failure, restart the instrument and check the reliability of the communication link. Longitudinal crack height measurements Mattel ultrasonic flaw detector before measurement, the probe zero and K values ??are required calibrated. The instrument does not support this feature. Procedure: 1. adjust the detection range is adjusted to the proper position to echo waveform display area. 2. Determine the endpoint A (the crack endpoint) Location: to move the probe, with the current gate locked flaw echoes, echoes of the most significant find defects (ie, defects echo peak). A key and select the endpoint parameters button, the instrument automatically locks and record the location of the peak of the echo, which is the end of the crack position P1. Determine the endpoint B (crack at endpoint) Location: to continue to move the probe to find the rear lower crack endpoint diffraction wave of industrial x-ray flaw detector, with the gate locked diffracted wave, and then select the endpoint B parameter entry and press the key, the instrument automatically locks and crack the lower end of record position of the point P2. After the endpoint A and endpoint B measurement is completed, the instrument automatically calculated based on the crack crack probe angle end position and height H, and show the crack altimeter Parameters box. Prices welding flaw detector, detector, US Tyco Tyco is provided by the United States and Technology Co., Ltd. Beijing. Beijing-US Science and Technology Co., Ltd. Tyco (www.mitech-ndt.com) strong, credible, electronic measuring instruments industry in Beijing's Haidian District, accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead the US Tyco into the brilliant and you work for a better future!